TESTS AND ADJUSTMENTS
5-5
5
Figure 5-11
6. Turn the camshaft clockwise until the cam lobe is
180° away from the tappet and remove the shim (5)
from the tappet by lifting at the cutaway.
Figure 5-12
7. Measure the thickness of the removed shim, and
determine the required thickness of the new shim
using the following equation:
IMPORTANT
If the value “A” equals an odd number, use a shim
0.01 smaller than “A” value.
Shim Selection Chart
TN0363
5
TN0364
A = B + (C – 0.20 mm)
Where
A
: Required thickness of new shim (mm)
B
: Thickness of removed shim (mm)
C
: Valve clearance measured (mm)
Part Number
Stamped
Number
Thickness
(mm)
4148102 218 2.18
4148103 220 2.20
4148104 222 2.22
4148105 224 2.24
4148106 226 2.26
4148107 228 2.28
4148108 230 2.30
4148109 232 2.32
4148110 234 2.34
4148111 236 2.36
4148112 238 2.38
4148113 240 2.40
4148114 242 2.42
4148115 244 2.44
4148116 246 2.46
4148117 248 2.48
4148118 250 2.50
4148119 252 2.52
4148120 254 2.54
4148121 256 2.56
4148122 258 2.58
4148123 260 2.60
4148124 262 2.62
4148125 264 2.64
4148126 266 2.66
4148127 268 2.68
4148128 270 2.70
4148129 272 2.72
4148130 274 2.74
4148131 276 2.76
4148132 278 2.78
4148133 280 2.80
4148134 282 2.82
To Next Page
Loading...
