Suzuki K6A-YH6 - Crankshaft Baffle; Oil Pressure Sending Unit

7-32
REPAIR
7
Crankshaft Baffle
Removal and Installation
See Figure 7-77.
1. Remove oil pan. (See “Oil Pan” on page 7-30.)
2. Remove oil pump pickup. (See “Oil Pump Pickup” on
page 7-31.)
Figure 7-77
NOTE
Cap screws (1) require the use of a 12-point 8 mm
socket.
3. Remove cap screws (1 and 2) and crankshaft
baffle (3).
Installation Notes
Install crankshaft baffle by reversing the order of removal.
Install oil pump pickup. (See “Oil Pump Pickup” on
page 7-31.)
Install oil pan. (See “Oil Pan” on page 7-30.)
Oil Pressure Sending Unit
Removal and Installation
See Figure 7-78.
Figure 7-78
1. Remove oil pressure sending unit (1).
2. Inspect oil pressure sending unit. Replace as
needed.
Installation Notes
Apply thread sealant to the oil pressure sending unit
before installation.
Install oil pressure sending unit by reversing the order of
removal.
Required Tools
12-Point 8 mm Socket
TN0743
3
2
1
TN0715
1