7-8
REPAIR
7
7.2 Electrical System
Ignition Coils
Removal and Installation
See Figure 7-18.
Figure 7-18
1. Remove cap screws (1).
2. Remove ignition coils (2).
3. Inspect ignition coils. Replace as needed.
Installation Note
Install ignition coils by reversing the order of removal.
Spark Plugs
Removal and Installation
See Figures 7-19 and 7-20.
Figure 7-19
1. Remove ignition coils. (See “Ignition Coils” on
page 7-8.)
2. Remove spark plugs (1).
Figure 7-20
3. Inspect spark plug (2) for signs of wear or damage.
Replace as needed.
4. Set spark plug electrode gap (3) to specification.
Spark Plug Gap: 0.031—0.035 in. (0.8—0.9 mm)
Installation Note
Install spark plugs by reversing the order of removal.
TN0695
1
2
TN0697
1
TN0698
2
3
To Next Page
Loading...
