Suzuki K6A-YH6 - Oil Pump Pickup

REPAIR
7-31
7
Installation
See Figures 7-74 and 7-75.
1. Clean cylinder block, front cover, and oil pan mating
surfaces.
Figure 7-74
2. Apply Three Bond™ 1215 Sealant to the oil pan
mating surface as shown.
Figure 7-75
3. Install oil pan (3) using three nuts (1) and twelve cap
screws (2). Tighten to specification.
Oil Pan Torque: 97 lb-in. (11 N•m)
4. Fill engine oil. (See “Change Engine Oil” on
page 3-2.)
Oil Pump Pickup
Removal and Installation
See Figure 7-76.
Figure 7-76
1. Remove oil pan. (See “Oil Pan” on page 7-30.)
2. Remove cap screws (1), oil pump pickup (2), and
O-ring (3).
3. Inspect oil pump pickup and O-ring. Replace as
needed.
Installation Notes
Always use new O-rings, gaskets, and seals.
Install oil pump pickup with new O-ring by reversing the
order of removal.
Install oil pan. (See “Oil Pan” on page 7-30.)
Required Materials
Three Bond™ 1215 (Suzuki PN 99000-1080-15A) or
equivalent
TN0397
TN0741
1
1
1
2
2
2
2
3
TN0742
1
2
3