3-2
MAINTENANCE
3
Engine Oil Level
See Figure 3-1.
Figure 3-1
1. Park the vehicle on a level surface.
2. Operate the engine until normal operating
temperature is reached.
3. Stop the engine. Remove dipstick (3) and wipe clean.
Install and remove dipstick again.
4. Check engine oil level.
If oil level is at or below low mark (1), add oil until the
level reaches the full mark (2).
5. Install dipstick (3).
Change Engine Oil
See Figure 3-2.
Figure 3-2
1. Park the vehicle on a level surface.
2. Operate the engine until normal operating
temperature is reached.
3. Stop the engine and place a suitable pan under the
engine.
!
WARNING
4. Remove drain plug (1) with seal (2) and drain engine
oil.
NOTE
Always use new O-rings, gaskets, and seals.
5. Install drain plug (1) using new seal (2). Tighten to
specification.
Drain Plug Torque: 36 lb-ft (49 N•m)
6. Add new engine oil through cylinder head cover until
oil level reaches full mark on dipstick.
Engine Oil Capacity: 2.9 qt (2.7 L) without oil filter
7. Start engine and check for leaks.
8. Stop engine and check engine oil level. Top off as
needed.
Oil Filter
Replacement
See Figures 3-3 and 3-4.
Figure 3-3
1. Drain engine oil.
TN0533
1
2
3
TN0534
1
2
The engine oil will be hot. Avoid skin contact with
used engine oil.
Required Tools
Oil Filter Wrench (Suzuki PN 09915-47340)
1
TN0694
To Next Page
Loading...
