Suzuki K6A-YH6 - Water Temperature Sensor; Thermostat Housing

REPAIR
7-11
7
Water Temperature Sensor
Removal and Installation
See Figure 7-29.
Figure 7-29
1. Remove water temperature sensor (1) and
O-ring (2).
2. Inspect water temperature sensor. Replace as
needed.
Installation Notes
Always use new O-rings, gaskets, and seals.
Install water temperature sensor by reversing the order of
removal.
Thermostat Housing
Removal and Installation
See Figures 7-30 and 7-31.
Figure 7-30
1. Remove thermostat. (See “Thermostat” on
page 7-10.)
2. Remove cap screw (1) and bracket (3).
3. Remove nuts (4) and thermostat housing (2).
Figure 7-31
4. Remove thermostat housing gasket (5).
5. Inspect thermostat housing for damage. Replace as
needed.
Installation Notes
Clean cylinder head and thermostat housing mating
surfaces before installation.
Always use new O-rings, gaskets, and seals.
Install thermostat housing by reversing the order of
removal.
Install thermostat. (See “Thermostat” on page 7-10.)
TN0701
1
2
TN0707
1
2
3
4
TN0708
5