Suzuki RGV250T 1996 - Page 84

3·51 ENGINE
• I nstall the bearing CD and two thrust washers CID to the
conrod.
•
Be sure to install the pistons in the cylinders from which
they were taken out in disassembly, refer to the letter mark,
"1" and "2", scribed on the piston.
• Apply engine oil
to the conrod and crankshaft bearings.
• The arrow mark on
the piston crown points to the exhaust
port side.
•
The circlip should be mounted in such a position that the
mating ends of the circlip do not coincide with the groove
portion
@ of the piston.
• Before inserting
the piston in the cylinder, be sure to apply
oil
to the outer surface of the piston ring grooves.
• It
is extremely important that, when the piston is fed into
the cylinder, each ring in place should be so positioned as to
hug the locating pin.
• I nstall new gaskets and positioning pins properly.
• Press
in the oil seal CD. Apply oil to the lip part of oil seal.