Suzuki RGV250T 1996 - Page 85

• Install the oil seal retainer CID.
• Assemble. the exhaust valve @ and valve guide @ properly
referring
to the markings:
Mark
"17" on valve to match with mark "18" on guide.
Mark
"19" on valve to match with mark "20" on guide.
• Install
the spacer @ with its chamfer side facing top.
• I nstall the valve pin
® with the flange ® side facing the
markings "19" and "20".
• Insert the exhaust valve assembly into the cylinder.
• Assemble
the valve shaft @, shaft arm (j) and spacer ® on
the cylinder.
• Tighten
the lock bolt @ on the arm so that the screw point
engages with a hole drilled in the shaft. Apply TH READ
LOCK
"1342" to the lock bolt.
99000-32050: THREAD LOCK
"1342"
• I nstall the valve pulley lever (j]) and washer @.
ENGINE 3-52