3·53
ENGINE
• Install
the
cylinder cover.
• Position
the
cylinder gasket
CD
on
the
crankcase.
• Apply oil
to
the
piston and cylinder sliding surfaces.
NOTE:
Make sure
that
each piston ring
end
gap
position
is
proper,ly
matching the locating pin.
• Push in
the
cylinder dowel pin
<ID
by hand.
• Install
the
cylinder over
the
piston slowly and carefully so
as
not
to
damage
the
piston ring.
• Position
the
cylinder head gasket
@.
Tightening torque: 23 - 27 N·m (2.3 - 2.7 kg-m)
• Install
the
cylinder head
@.
On
the
two stud bolts
out
of
total five, a copper washer and cap
nut
@ should be fitted.
• I nstall
the
water pipe elbow connector ® together with
the
clamp
(j).
Tightening torque: 23 - 27 N·m (2.3 - 2.7 kg-m)
NOTE:
Carry
out
the
same
procedures to assemble the
Left
cylinder
parts.
Note
that the clamp
is
not
needed on the hose
elbow
connector (j)
for
the
Left
cylinder.
To Next Page
Loading...
