18
REAR
The procedure to bleed the rear brake is identical to
that of the front.
A: Bleeder valve
FRONT BRAKE LEVER
Check the brake lever play.
Front brake lever play: 5–20 mm
If adjustment is necessary, carry out the procedure
below:
1. Loosen the lock nut A.
2. Turn the adjuster B in or out until the correct play.
3. Tighten the lock nut A.
THROTTLE CABLE
Check the throttle cable play at the throttle grip A.
Throttle cable play: 2.0–4.0 mm
If adjustment is necessary, carry out the procedure
below:
1. Loosen the throttle cable adjuster lock nut B.
2. Turn the adjuster C in or out until the correct play.
3. Tighten the lock nut B while holding the adjuster.
4. Place the rubber boot D.
#
After the adjustment is completed, check that
handlebar movement does not raise the engine
idle speed and that the throttle grip returns
smoothly and automatically.