Suzuki RM85/LK5 - Front Fork Compression Damping Adjustment; Front Fork Adjuster Screw Warning (Compression); Front Fork Air Pressure Adjustment; Front Fork Air Pressure Caution

21
Compression Damping Force Adjustment
Adjust the setting of the compression damping force to
the standard position.
To adjust, turn the adjuster B clockwise until it stops
and then turn it counterclockwise until 7 clicks are felt.
#
Air Pressure Adjustment
Place a block under the chassis tube to lift the front
wheel off the ground.
Remove the air bleed screw C and equalize the air
pressure in the front forks to atmospheric pressure.
Re-fit the air bleed screw C.

REAR SUSPENSION
Rebound Damping Force Adjustment
Adjust the setting of the rebound damping force to the
standard position.
To adjust, turn the adjuster A clockwise until it stops
and then turn it counterclockwise until approximately 2
turns are felt and the two punch marks align.
#
Do not force the adjuster screw B
BB
B past the
stopped position or you may damage the
adjuster.
Be sure to adjust the damping force on both
front forks equally.
NOTE:
The specified front fork air pressure is 0 kPa (0
kg/cm
2
, 0 psi) for both fork legs.
Do not pump air into the front fork.
Do not force the adjuster screw A
AA
A past the
stopped position or you may damage the
adjuster.