20
5. After adjusting, tighten the axle nut to the specified
torque.
6. Tighten the lock nuts securely.
"
""
" Rear axle nut: 72 N·m (7.2 kgf-m)
Verify that the master link clip is installed properly.
The opening of the master link clip faces away from the
direction of travel.
A: Direction of travel
B: Master link clip
FRONT FORK
Rebound Damping Force Adjustment
Adjust the setting of the rebound damping force to the
standard position.
To adjust, turn the adjuster A clockwise until it stops
and then turn it counterclockwise until 1-1/2 turns are
felt.
#
Make sure that the rear sprocket is properly
aligned with the engine sprocket.
Verify the reference marks on the swing-arm by
sighting down along the chain from the rear
end of the motorcycle.
40–50 mm
Do not force the adjuster screw A
AA
A past the
stopped position or you may damage the
adjuster.
Be sure to adjust the damping force on both
front forks equally.
To Next Page
Loading...
