Suzuki SMD 9 - Restoring Fish Finder Factory Defaults

8. FISH FINDER
8-12
3. Set the [Depth] (from transducer) to set the start point for the detection area.
Drag the slider, or tap the keyboard icon to input a value.
4. Set the Range (width) of the detection area in a similar manner.
5. Close the menu.
8.19.3 How to set the fish size notification
The [Fish Size Notification] is triggered when fish meet the criteria set for the ACCU-
FISH
™
filter. See section 8.17.4 to set the criteria.
1. Tap [Home] => [Settings] => [Notifications] => [Fish and Bottom].
2. At [Fish Size Notification], tap the toggle box to show [ON].
3. Close the menu.
8.19.4 How to set the seabed type notification
The Bottom Discrimination feature gives you an estimate of the seabed composition
and you can set a notification to inform you when a certain composition is detected.
1. Tap [Home] => [Settings] => [Notifications] => [Fish and Bottom].
2. At [Seabed Type Notification], tap the toggle box for [Notification] to show [ON].
The composition types (Sand, Mud, Rock, Gravel) are now active and selectable.
3. Select the composition type you want to trigger the notification.
4. Set the [Probability] at which the notification is triggered.
Drag the slider, or tap the keyboard icon to input a value.
5. Close the menu.
8.20 Restoring Factory Defaults
You can reset Fish Finder menu settings back to factory default.
Note: This procedure resets ALL settings in the [Fish Finder] menu to default.
1. Tap [Home] => [Settings] => [Fish Finder] => [Restore Defaults]. A confirmation
message appears.
2. Tap [Yes] to restore the [Fish Finder] menu settings to factory default.