9. RADAR
9-7
• [Sector Start Angle]: Sets the angle at which [Sector Suppression] begins. This
menu item can be adjusted regardless of the setting for [Sector Suppression],
however the setting has no effect until [Sector Suppression] is enabled.
• [Sector Width]: Sets the width for [Sector Suppression]. This menu item can be
adjusted regardless of the setting for [Sector Suppression], however the set-
tings has no effect until [Sector Suppression] is enabled.
• [Video Contrast]: Sets the video contrast (sharpness) for radar echoes. This
menu option is only available when a radar antenna is connected.
• [Antenna Heading Align]: Aligns the antenna heading. This setting is done at in-
stallation and should not be changed during normal use.
3. Tap the [x] at the top-right corner of the menu to close the menu.
9.17 Restoring Factory Defaults
You can restore the [Radar] menu to factory default settings with the following proce-
dure.
1. From the [Home] screen, tap [Settings] => [Radar] => [Restore Defaults].
2. Tap [Restore Default Settings]. A confirmation pop up appears.
3. Tap [Yes] to restore the menu to factory default settings, or tap [No] to cancel.
4. Tap the [x] at the top-right corner of the menu to close the menu.
To Next Page
