Suzuki VL800 - Throttle Body Removal

104 VL800K5 (’05-MODEL)
THROTTLE BODY REMOVAL
• Remove the air intake pipe. ($Page 103)
• Disconnect the TP sensor lead wire coupler

1, STVA lead
wire coupler

2 and STP sensor lead wire coupler

3.
• Disconnect the fuel injector lead wire couplers

4.
• Disconnect the vacuum hoses

5.
• Loosen the throttle body clamp screw at the intake pipe side.
• Disconnect the throttle cables from their drum.
#
After disconnecting the throttle cables, do not snap
the throttle valve from full open to full close. It may
cause damage to the throttle valve and throttle body.
SAMPLE