VL800K5 (’05-MODEL) 11
SHAFT DRIVE
Unit: mm (in)
THERMOSTAT + RADIATOR + FAN + ENGINE COOLANT
Shift fork groove width
No.1
5.50 – 5.60
(0.217 – 0.220)
----
No.2
4.50 – 4.60
(0.177 – 0.181)
----
Shift fork thickness
No.1
5.30 – 5.40
(0.209 – 0.213)
----
No.2
4.30 – 4.40
(0.169 – 0.173)
----
ITEM STANDARD LIMIT
Secondary bevel gear backlash 0.05 – 0.32
(0.002 – 0.013)
----
Final bevel gear backlash
Drive side
0.03 – 0.064
(0.001 – 0.025)
----
Damper spring free length
----
58.5
(2.30)
ITEM STANDARD/SPECIFICATION NOTE
Thermostat valve opening
temperature
Approx. 75 °C (167 °F) ----
Thermostat valve lift Over 6 mm (0.24 in) at 90 °C (194 °F) ----
ECT sensor resistance 20 °C
(68 °F)
* Approx. 2.45 kΩ ----
40 °C
(104 °F)
* Approx. 1.148 kΩ ----
60 °C
(140 °F)
* Approx. 0.587 kΩ ----
80 °C
(176 °F)
* Approx. 0.322 kΩ ----
Radiator cap valve opening
pressure
95 – 125 kPa
(0.95 – 1.25 kgf/cm², 13.5 – 17.8 psi)
----
Cooling fan thermo-switch
operating temperature
OFF→ON Approx. 105 °C (221 °F) ----
ON→OFF Approx. 100 °C (212 °F) ----
Engine coolant type Use an antifreeze/coolant compatible with aluminum
radiator, mixed with distilled water only, at the ratio of
50:50.
----
Engine coolant capacity 1 500 ml
(1.6/1.3 US/lmp qt)
----
ITEM STANDARD LIMIT
SAMPLE
To Next Page
Loading...
