90 VL800K5 (’05-MODEL)
SENSORS
CKP SENSOR INSPECTION
The crankshaft position sensor is installed in the generator
cover. ($Page 46)
CKP SENSOR REMOVAL AND INSTALLATION
• Remove the generator cover. ($VL800K1 3-18)
• Install the generator cover in the reverse order of removal.
IAP SENSOR INSPECTION
The intake air pressure sensor is installed on the air intake pipe.
($Page 49)
IAP SENSOR REMOVAL AND INSTALLATION
• Remove the fuel tank. ($Page 93)
• Remove the IAP sensor from the air intake pipe.
• Install the IAP sensor in the reverse order of removal.
TP SENSOR INSPECTION
The throttle position sensor is installed at the right side of the
No.2 (Front cylinder) throttle body. ($Page 52)
TP SENSOR REMOVAL AND INSTALLATION
• Remove the TP sensor. ($Page 105)
• Install the TP sensor in the reverse order of removal.
TPS ADJUSTMENT
• Adjust the TP sensor. ($Page 33)
ECT SENSOR INSPECTION
The engine coolant temperature sensor is installed at the cylin-
der head cover. ($Page 57)
ECT SENSOR REMOVAL AND INSTALLATION
• Remove the fuel tank. ($Page 93)
• Remove the ECT sensor.
• Install the ECT sensor in the reverse order of removal.
* ECT sensor: 18 N·m (1.8 kgf-m, 13.0 lb-ft)
SAMPLE
To Next Page
Loading...
