SV 104 USER'S MANUAL_DRAFT_______________________________________________
_
29
TURNING OFF: To shut down the unit the operator should hold the <ENTER> key for a couple
of seconds during which a countdown (“Shutting down” 3… 2… 1… ) is displayed. Thus, the SV 104 gives
you time to decide if you really want to turn off the instrument. If you release the key too early, the SV 104
returns to the last presented VIEW mode.
If enabled in the configuration setup there may be presented an additional, double-check, warning
screen. This is for the operator to be aware and convinced the unit is really to be turned off. See figure
below:
Figure 4-1 Power-off warning screen
Notice: SV 104 will automatically shut down after 5 minutes in stopped (ready to measure)
mode.
Notice: If auto-run (timer) mode is active, SV 104 will automatically stop the measurement
when the set time is over and then turn off. If no auto-run mode is used and specific time has not been
preset, the unit will continue to measure until the battery is exhausted. Just before switch off,
the measurement run will be stopped and all data until that point will be saved securely for later
download to the PC.
To Next Page
Loading...
Need help?
General
