SV 104 USER'S MANUAL_DRAFT_______________________________________________
_
40
5 SUPERVISOR BASIC OPERATIONS
This chapter explains data storage, the configuration setup of the dosimeter, and how to customize
the parameters via the Supervisor software.
With use of micro USB cable, software, and SV104, it is easy to:
set up required configuration parameters and download these, so called SETUPS, straight
to the SV 104 instrument
retrieve time history data to view and analyze your noise recorded charts, graphs,
with extended reporting functionality
5.1 Installing and connecting to PC
Insert the Supervisor software CD/DVD into your PC and run the installation program.
After installation we are ready to connect the SV 104 dosimeter.
Plug the USB cable into the computer
Plug the opposite end of the cable (micro USB) into the dosimeter itself
The SV 104 is powered and charged directly through the computer; thus, you do not need
separate charger. The dosimeter screen will be switched on automatically with current
charging information only
Turn on the dosimeter (see chapter 4.3) - long press of the <ENTER> key
Windows will install drivers for Svantek instruments if not previously installed
Once switched on, run the Supervisor software.
Figure 5-1 Supervisor splash screen
Notice: Supervisor software enables communication with multiple dosimeters. Therefore,
with the use of a USB hub such as the SA 156 it is pretty straightforward to connect all of them at the same
time. Just make sure your computer system has enough power capability (see chapter 4.1 for details).
To Next Page
Loading...
Need help?
General
