To Next Page

To Previous Page

SV 104 USER'S MANUAL_DRAFT_______________________________________________

Figure 4-11 Calibration - microphone not in tolerance screen

9. Post calibration. If enabled, the post processing is performed automatically under acceptance

of calibration measurement.

Notice: If it is required to perform so called post-calibration of the instrument. In case the

Post Calibration is pre-programmed within configuration setup the SV 104 automatically adds the results

to the previously saved files.

Table of Contents3
Introduction8
Sound Pressure9
Dosimetry9
Table 1-1 Example Sound Source Levels9
Standards10
Applications11
Measurement Procedures12
Kit Components13
104 Dosimeter Short Form Specification13
Figure 2-1 Sv 104 Instrument with the Microphone and Windshield13
Accessories Included14
Accessories Available14
Instrument Software (Firmware) Options Available14
Getting Started15
System Description15
Figure 3-1 Sv 104 at a Glance15
Input Output Interfaces Description16
Figure 3-2 Sv 104 Side View - Microphone and Micro Usb Connector16
Figure 3-3 SV 104 Back View - Charging and Infrared Port (Reserved for Future Use)16
The Windshield17
The Mounting Clips17
Figure 3-4 Sa 122 Windshield17
Figure 3-5 Sv 104 Standard Mounting Clips17
LED Status Indicator18
Status Bar Icons18
Figure 3-6 Sv 104 Display Icons Description18
Manual Control of the Instrument19
Primary Key Functions20
Figure 3-7 Control Keypad on the Front Panel - Primary Key Functions20
Alternate Key Functions21
Figure 3-8 Control Keypad on the Front Panel - Alternate Key Functions21
Alternate Combined Keys Function22
Figure 3-9 Control Keypad on the Front Panel - Alternate Combined Keys Function22
Three Instruments in One - ACOUSTIC PROFILE Concept23
The VIEW Mode Presentation Concept23
Running SPL View Mode23
Figure 3-10 Running Spl View Mode Screen23
Primary "ONE-RESULT" Parameters View Mode24
RESULTS LIST View Mode24
Figure 3-11 Primary Parameters View Mode Screen24
Figure 3-12 Results List View Mode Screens24
OCTAVE Analysis Spectrum View Mode25
Figure 3-13 Octave Analysis Spectrum Graph Leq View Mode Screens25
Figure 3-14 Octave Analysis Spectrum Graph Max View Mode Screens25
INSTRUMENT STATUS View Mode26
ALARM Screen Review26
Figure 3-15 Instrument Status View Mode Screens26
Figure 3-16 Alarm View Screens26
Running and Operating Basic Procedures27
Charging27
Before You Turn the Instrument on28
Turning On/Off28
Figure 4-1 Power-Off Warning Screen29
Battery Check30
Figure 4-2 Instrument Status - Battery State30
Reviewing Unit Label31
Figure 4-3 Unit Label Screens31
Measurement Setups - Basic Configuration32
Figure 4-4 Load Setup Menu32
Figure 4-5 Load Setup Confirmation32
Figure 4-6 Status of Setup Loading32
Calibration33
Figure 4-7 Calibration Menu33
Figure 4-8 Calibration - Initial Delay Screen34
Figure 4-9 Calibration in Progress Screen34
Figure 4-10 Calibration Confirmation Screen34
Figure 4-11 Calibration - Microphone Not in Tolerance Screen35
Voice Comments Recording36
Figure 4-12 Voice Comment Linking Screen36
Figure 4-13 Voice Comment Recording Command Screen36
Figure 4-14 Voice Comment Recording in Progress Screens36
Figure 4-15 Voice Comment Record Confirmation Screen36
Before and after Measurement Run37
Starting and Stopping Measurement Run37
Auto-Run Mode Information37
Figure 4-16 Auto-Run Mode - Timer and Programmable Pause Screen37
Security Lock38
Mounting and Positioning the SV 10438
Figure 4-17 Unlocking the Unit Sequence Screens38
Reviewing Measurements39
Resetting the Dosimeter39
Supervisor Basic Operations40
Installing and Connecting to PC40
Figure 5-1 Supervisor Splash Screen40
Main Software Window41
Instruments Inventory Panel42
Figure 5-3 Inventory Panel and Its Capabilities42
Advanced Configuration Setup43
Working with Configuration Setup Files43
Figure 5-5 Exporting the Configuration Setup File44
Figure 5-6 Instrument Files Panel and Context Commands45
Profile Settings Tab46
Figure 5-7 Dosimeter Settings - Profile Configuration Tab46
Measurement Parameters Settings Tab47
Figure 5-8 Measurement Configuration Setttings Tab47
Time-History Data Logging Settings Tab48
Figure 5-9 Time History ( Logger ) Settings Tab48
Display VIEW Configuration Tab49
Figure 5-10 Display View Configuration Tab49
Octave Analysis Spectrum Configuration Tab50
General Settings Tab50
Figure 5-11 Spectrum Configuration Tab50
Figure 5-12 General Settings Tab50
Calibration Settings Panel51
Statistical Levels Settings Panel51
Figure 5-13 Calibration Settings Panel51
Figure 5-14 Statistical Levels Settings Panel51
Security Settings Panel52
Figure 5-15 Keyboard Security Settings Panel52
Auxiliary Settings Panel53
Figure 5-16 Auxiliary Settings Panel53
Auto-Run Settings (Timer, Pauses) Tab54
Figure 5-17 Auto-Run Configuration Tab54
Recording Options Tab56
Event and Wave Recording Configuration Panel56
Figure 5-18 Audio Event and Wave Recording Configuration Panels56
Working with Data Files57
Instrument Files57
Figure 5-20 Change Instrument Working Directory Window57
Local Files "Data Browser58
Figure 5-21 Local Files "Data Browser" - Window Layout58
Working with Sessions and Reporting59
Supervisor Main Session Window59
Session Configuration Panel59
Report Panels61
Figure 5-24 Managing Templates with Supervisor61
Supervisor Report Options61
Figure 5-26 Hearing Protectors (Hml) Panel62
Figure 5-27 Instrument Configuration Panel62
Figure 5-28 Logger 1/1 Octave Panel63
Figure 5-29 Logger 1/1 Octave Tsect Panel63
Figure 5-30 Logger Combined Panel63
Figure 5-31 Logger Results Panel64
Figure 5-32 Logger Statistics Panel64
Figure 5-33 Marked Periods Totals Panel65
Figure 5-34 Noise Exposure (Iso 9612) Panels65
Figure 5-35 Session Header Panel66
Figure 5-36 Configurable Text Panel66
Figure 5-37 Powerfull "What If" Panel66
Sv104 Maintenance67
General Recommendations for Use67
Cleaning67
In Situ Calibration67
Periodic Testing67
Changing the Microphone and Windshield68
Firmware Update68
Storing the Instrument68
Transportation and Carrying69
Troubleshooting69

Brand	Svantek
Model	SV 104
Category	Measuring Instruments
Language	English

Svantek SV 104 User Manual

Table of Contents

Questions and Answers:

Svantek SV 104 Specifications

Related product manuals