Svantek SV 104 User Manual

SV 104 USER'S MANUAL_DRAFT_______________________________________________
_
49
5.4.5 Display VIEW configuration tab
As mentioned in chapter 3.9 there are quite a few VIEW modes accessible on the display, when
the dosimeter is performing a measurement run.
 In the left panel named “Modes views” you can select which VIEW mode will be present
when you press the <ENTER> key on the dosimeter keypad
Notice: If you do not want to use all three ACOUSTIC PROFILES it would be
convenient for you to enable only one acoustic PROFILE to be displayed – just select the
required one.
Notice: The “ONE-RESULT” (chapter 3.9.2) is the only VIEW mode that is
always present, and cannot be disabled.
 In the right panel named “Display Results”, you will find a list of over a dozen
measurement parameters, that can be configured to be presented on the SV 104 display,
when you press <SCROLL> key. See Appendix D to review acronyms for each
parameter.
Figure 5-10 Display VIEW configuration tab
Up to three
profiles can be
switched on

Svantek SV 104 Specifications

General

Brand	Svantek
Model	SV 104
Category	Measuring Instruments
Language	English