1. Place the drone on a level surface, power on the remote
controller, then the drone. Wait for the aircraft to connect to the
remote controller.
2. Hold the left joystick up to its highest position, then quickly
move the right joystick left to right, back and forth, until the front
and rear status indicators flash alternately, or the remote
controller screen prompts "Aircraft Initializing，Please Wait". The
drone will now perform IMU calibration. Now release the joysticks.
This process will be completed in 20 seconds. Do not move the
drone during this process.
3. When the front status indicators turn soild red and the rear
status indicators turn solid green, or "Aircraft Initializing，Please
Wait" prompt disappears, power off and restart the drone. IMU
calibration is complete.
⚠1) Never calibrate the IMU on a boat or other moving platforms. 2) When the drone is
floating on water, it may occasionally prompt IMU calibration, which is normal and can
be ignored. 3) If the calibration fails, the "Aircraft Initializing，Please Wait" prompt will
not disappear, please follow the steps, and try to calibrate again.
Basic Flight Steps
1. Check that the aircraft is correctly assembled.
2. The propellers are correctly mounted and secure.
3. The battery hatch is closed and locked.
4. The silicone plug on the back of the remote controller is closed.
5. The mobile device is securely mounted to the remote controller.
6. Place the aircraft on flat open ground or water.
7. Power on the remote controller, followed by the drone.
8. Connect the mobile phone to the remote controller Wi-Fi.
9. Open the App and wait for the camera image to Appear and the flight data display is
normal.
10. Check the following flight data: flight battery> 16.0V; remote controller battery> 1
bar; Satellite > 5.
11. For your safety, you should stand upwind and at least 3 meters away from the drone.
12. Novice pilots should always take off in GPS mode.
13. Arm the drone or use the auto take-off on the App.
14. Push the left(throttle) joystick up slowly, allowing the drone to take off smoothly.
Release the throttle when the drone is Approximately 1.5 m high. Allow the drone to
hover for a moment to ensure flight stability.
15. When you need to descend, gently pull down the left(throttle) joystick, allowing the
drone to descend and land on a flat surface or the water.
To Next Page
Loading...
