EasyManua.ls Logo

SWELLPRO SplashDrone 4 - Battery Management; Battery Care and Maintenance

SWELLPRO SplashDrone 4
64 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
©2022 SwellPro All Rights Reserved 60
Warranty Information
Please visit the SwellPro support website support.swellpro.com. Search "After-sales
Policy" for warranty information.
Battery Care and Maintenance
Do not allow the batteries to come into contact with any kind of liquid.
Do not drop the battery into the water.
Do not leave batteries out in the rain, or near any sources of moisture. If the
inside of the battery comes into contact with water, chemical decomposition
may occur, potentially resulting in the battery catching on fire, and may even lead
to an explosion.
Never use or charge swollen, leaky, or damaged batteries. If your batteries are
abnormal, please contact SwellPro or a SwellPro authorized dealer for further
assistance.
The battery can be used in temperatures ranging from -10°C to 40°C. Using the
battery in environments above 60°C can lead to a fire or explosion. Using the
battery below -10°C can lead to permanent damage.
Never disassemble, or penetrate the batteries with sharp objects, otherwise, this
may result in the battery catching fire, or even lead to an explosion.
Electrolytes in the battery are highly corrosive. If any electrolytes make contact
with your skin or eyes, immediately wash the affected area with fresh running
water for at least 15 minutes, and then see a doctor immediately.
If the battery falls into water, pick it up immediately and put it in a safe and open
area. Maintain a safe distance from the battery until it is completely dry. Never
use the battery again, and dispose of the battery properly as described in the
Battery Disposal section below.
Do not heat batteries. A battery fire can be extinguished using sand, or a dry
powder fire extinguisher.
Do not put batteries in a microwave oven, or a pressurized container.
Do not put the loose battery cells onto any conductive surface, such as a metal
table.
Do not put any conductive cables or metal objects together with batteries, where
they may short-circuit against each other.
Do not drop or strike batteries.
Do not place heavy objects on the batteries or the battery charger.
Clean battery terminals with a clean, dry cloth. Failure to do so may result in poor
electrical contact, which could reduce the battery capacity, or damage the
charger.
Do not continue to fly the drone after the low battery alarm has been activated;
this will result in over-discharging the battery, and potentially could damage the
battery cells.

Table of Contents

Other manuals for SWELLPRO SplashDrone 4

Related product manuals