©2018 SwellPro All Rights Reserved
11
The drone has two return home modes - automatic and manual return home. Since the Spry remote
controller has a built-in GPS module, the remote controller constantly sends the Spry its location so that the
drone can return to the pilot even if they have moved from the take-off point. If the drone loses contact with
the remote control for any reason, then the drone will automatically return to the last known location of the
remote controller. Manual return home can also be initiated with the remote controller.
When returning home, the Spry will wait and hover 30m from the remote controller to allow the pilot to take
control of the landing if necessary.
Return Home
One Key Return Home Function
Description
Remote Control Operation
Press and hold the Return Home switch for 2 seconds, the system will
beep and start the return process. At this point, the aircraft will
auto-return to the remote controller . “RTH” is displayed in the upper
right corner of the remote control screen.
To cancel the Return Home process, press and hold the Return Home
switch for 2 seconds, the system will beep and cancel the return process
Vertical height > 20metres, the drone will maintain its altitude and
return to its home point.
Vertical height < 20metres, horizontal distance > 15metres, the drone
will ascend up to 20metres, and then return to its home point.
Return Process
Description
Flare Maneuver
Return Home
If the drone experiences a loss of GPS signal, the Return Home function is temporarily unavailable. The
aircraft will hover in place until either control is restored or automatic low-battery landing takes place.
During automatic Return Home, when the remote control signal is restored, switch the Flight Mode
briefly between GPS and ATTI mode to take control of the drone and cancel automatic return.
To Next Page
Loading...
