SWELLPRO spry - APP Control; How to Use

©2018 SwellPro All Rights Reserved
26
GPS
80%
10
Automatic takeoff
Phone location
Return home
(return to the
remote controller)
Hover
Attitude meter
Flight path
disconnected
Connection status
Point to fly
Drone information
Flight mode GPS signal
Remote control signal
Battery capacity
Photo/Video
mode
Shutter
Horizontal distance
Vertical distance
Ascent/descent speed
Flight speed
Coordinate information
10 10
-10 -10
0
I
I
I
I
I
I
I
I
I
D: 0.0m H: 0.0m H.S: 0.0m/s V.S: 0.0m/s
Lat：113.860667 Ing：22.704291
APP Control
How to Use
The Spry remote controller has a built-in WI-FI module that can be used to connect your mobile device and
control the aircraft to perform various intelligent automatic flight modes with the Spry APP.
APP installation:
The Spry app is available for iOS and Andoid devices. Android systems can download the
APK from either the Android market or our website www.swellpro.com.
To connect the app to the Spry’s remote controller, power on the remote controller and drone, then connect
your mobile device to the WiFi hotspot called SP_FF1.....
After successfully connecting, open the APP to display realtime data from the drone such as voltage,
coordinates, altitude, distance, GPS signal and other flight parameters.
Be aware of the direction of the wind relative to the boat. Even when at anchor, it is possible that the wind
will not be at the nose of the boat.
Always try and take off with the wind so that the drone will be taken away from the boat.
When landing the drone onto a boat, if possible land against the wind so that the drone will be held away
from the boat.
If the boat is rocking, the Spry may not arm its motors in GPS mode. In this case, carefully take-off in ATTI
mode and then switch to GPS mode if there are sufficient satellites.
For safety, it is not recommended to launch or land your SplashDrone from your hands.