©2018 SwellPro All Rights Reserved
22
Accelerometer (Gyroscope) Calibration
Accelerometer calibration is necessary if:
a. The drone is brand new.
b. The drone has been flown extensively in in ATTI mode.
c. When in GPS flight mode and using only the THROTTLE joystick, the drone drifts at an angle.
d. The drone has been subjected to heavy shaking during transportation.
Preparation Before your First Flight (or in a new location)
The drone relies on very sensitive sensors to control flight positioning and stability. The accelerometer
(gyroscope) and compass sensors need to be calibrated before flying in a new location or if the drone has
suffered undue shock or excessive vibration.
DescriptionRemote Control Operation
Accelerometer Calibration Steps:
The safety fence applies in all flight modes.
1. Place the drone on a horizontal surface, power on the remote controller
and the drone. Wait for the FPV interface to finish initialization.
2. Pull the left joystick down to the lowest position and then fast flick the
right joystick left and right continuously until INITIALIZING……appears
on the FPV screen.
3. The drone will now perform calibration adjustments. Do not move or
disturb the drone during this process. When the INITIALIZING message
disappears from the FPV display, the process is compete.
Maximum flight radius: 800meters
Maximum flight height: 200meters
Home point
4. Push the left joystick up to the highest position and then fast flick the
right joystick left and right continuously until INITIALIZING……appears
on the FPV screen.
5. The drone will now perform further calibration adjustments. Do not
move or disturb the drone during this process. When the INITIALIZING
message disappears from the FPV display, the process is compete.
6. Please power off and restart the drone.
According to provisions of the International Civil Aviation Organization and many national air traffic
regulations, drones must be operated in specified airspaces.
The Spry is configured to not exceed an altitude of 200m and a distance of 800m from the remote controller.
To Next Page
Loading...
