©2018 SwellPro All Rights Reserved
21
Alternating Green-Red fast flash
Green ON
WiFi ON
Camera in preview mode
Green slow flash Camera recording
Camera Settings
EV
White Balance
Distortion Correction
Metering
Format
About this device
Restore Settings
+2.0 +1.7 +1.3 +1.0 +0.7 +0.3 0.0 -0.3 -0.7 -1.0 -1.3 -1.7 -2.0
AUTO, cloudy, sunny, Incandescent lamp, Fluorescent lamp
ON OFF
Global metering, Center-weighted, spot
Confirm Cancel
firmware details
Confirm Cancel
Camera Indicator
When electronic stabilization is on, distortion correction will also be turned on.
Flight Restrictions
This section describes flight considerations, flight restrictions, and drone care.
Flight
Introducing you to Flying a Drone
Flying the Spry
If this is your first time flying a drone, please read this manual thoroughly and watch the instructional videos
on our YouTube channel. We recommend taking professional training and guidance. When flying, select an
environment appropriate to your skills.
It is advisable for all drone pilots to become familiar with flying in ATTI mode in case of GPS or magnetic
interference which can interfere with drone controls.
1. Although the Spry is waterproof, do not fly in fog or if the wind is very strong or gusting above Beufort
Force 4.
2. Select an open place or water surface as an ideal flying site.
Flying between or near large steel buildings could adversely affect the workings of the compass and can
adversely affect or block GPS and control signals.
3. During flight, try to maintain line of sight with the drone, keep away from obstacles and people.
4. Do not fly near high voltage power lines or communication towers which may interfere with the remote
controller of the drone.
5. When flying at altitudes above sea level, environmental factors including air density reduce the
performance of aircraft and therefore also propulsion batteries.
To Next Page
Loading...
