55--3344
⑮ Software Limit Setting
This function is to set whether to use the virtual frame limit setting function.
－ The default is “No.”
⒃ Thread Break Moving
This function is to set the length of automatic backward movement of the frame in case where the machine is
stopped due to the sensing of thread break in order to make the upper thread placement much easier.
－ The default is 0[mm], and the setting range is from 0 to 50mm. The value can be set by the unit of 1[mm].
⒔ Lock Stitch
This function is to set the execution of multiple backtacks to prevent thread release upon trimming.
－ The default value is 1 stitch, and the value can be set at the odd number within the range of 1 to 5 stitches.
⒕ Auto Start After Color Change
When the thread color change code appears during embroidery, change the needle bar according to the needle
bar setting. This function is to determine whether embroidery is automatically started after the needle bar
change.
－ The default value is “Yes (1).”
To Next Page
Loading...
Need help?
General
