55--3333
⑧ Auto Back Stitch
When thread break is sensed, this function sets the number of backward stitches.
－ The default is 0 and the scope of adjustment is from 0 to 5 by the unit of 1 stitch.
⑨ Auto Start After Trimming
The function sets up whether embroidery automatically begins after jump code and trimming or trimming by
suspension code.
－ The default is “Yes.” If automatic start is not desired, enter “0” to choose “No.”
⑩ Auto Start After Frame Back
The function is to determine whether the machine is automatically started when the frame reaches “⑫ All
Needle Bars’ Starting Position After Back Stitching.”
－ The default is “Yes.” If automatic start is not desired, enter “0” to choose “No.”
⑪ All Head Swing After Stitch Back
The function is to decide whether the heads with broken thread are operated only or whether the needle bars
of all heads are operated in case where the frame is moved backward from the machine stop point, and the
embroidery work is begun with the bar switch.
－ The default is “single.” To operate the needle bars of all heads, press “0” to select “All.”
⑫ All Head Startpoint After F.B
When all or multiple needle bars are simultaneously in operation and the machine is stopped due to the
detection of a problem (thread break) affecting one needle bar, it is possible to conduct the back-stitching for
the concerned needle bar with the problem to correct the part where stitching did not occur. After that, if all
the needle bars are operated from the point which is located before the problem area, the embroidery will be
overlapped on the problem area, making correction. The function is to set the relative position of the entire
needle bar motion, and the value can be set at the range from 1 to 20[st]. The default is 2[st].
⑬ Frame Forward / Back Moving Unit
This function is to set the number of stitches to move by the one-time operation of the bar switch when the
frame is moved forward and backward with the bar switch.
－ The default is 1[st]. It can be set at the range of 1 to 10[st] by the unit of 1[st].
⑭ Optimize Method
The part where embroidery is conducted in the form of running stitch in a certain distance away from the
outline is called a gauge. This function is to set the distance between gauge and outline.
－ The default is 10[mm], and the setting range is from 1 to 30[mm].
To Next Page
Loading...
Need help?
General
