when emulations stops and editing of current program line is finished.
3.2. Special Keys
DM41X has several additional keys not present on original 41C models. Following list summarizes
all the additions:
‣ [ CST ] - Custom Menu key
Activates Custom Menu
‣ [ SHIFT ] [ CST ] - CONF
Activates Custom Menu configuration screen
‣ [ DSP ] - Change display key
Cycles view modes:
Calculation mode
• Stack view
• SI view XA
• SI view XY
Programming mode
• SI PRGM view - single line basic PRGM view
• Multiline PRGM view - 4 lines
• Multiline PRGM view - 6 lines
• Multiline PRGM view - 8 lines
‣ [ SHIFT ] [ DSP ] - PRN
The same as pressing 'PRINT' button on original 82143A thermal printer. See IR Printing for
more details.
‣ [ SHIFT ] [ PRG ] - SIZE
Invokes SIZE function.
‣ [ SHIFT ] [ USR ] - SETUP
Activates Main Setup menu.
‣ [ ▲ ] - Up Key
• Same as [ BST ] in SI, Stack and PRGM views
• [ SHIFT ] [ ▲ ] uses CST command (if defined) in SI and Stack views
• [ SHIFT ] [ ▲ ] Goes to top line of current program in PRGM mode
‣ [ ▼ ] - Down Key
• Same as [ SST ] in SI, Stack and PRGM views
9
To Next Page
Loading...
