• Save Active Modules (AM) List only
Saves list of modules present in current AM list (all modules are marked as active in saved file).
• Save Flash and AM Lists
Saves list of modules present in current AM List (marked as active in saved file) followed by list
of remaining non-active modules in flash area (marked as inactive in saved file).
Setup → Module → Load Modules
• Load Active Modules (AM) List
Fills AM List with active modules from given file.
All modules have to be already present in flash. See Module identification in flash for more
details.
• Load Flash and AM List
Clears module flash area and AM list.
Then loads all modules from given file into flash and fills AM list with active modules.
• Load Flash, clear AM List
Clears module flash area and AM list.
Then loads all modules from given file into flash and leaves AM list empty.
4.6. Activating Modules (plug-in)
Here 'Activating module' means to do an action which corresponds to module plug-in on real
calculator.
Note that it is possible to plug-in only modules present in Flash Module Area.
Steps
1. Activate Plug from 'Active Modules' screen:
SETUP → Module → Active Modules → Plug
2. List of modules from Flash Module Area is displayed
3. If required module isn’t present in the list you can import module from disk using Imprt now.
4. Select required module from list and press Add or [ ENTER ] to add module to 'Active Modules'
list.
You should see Active Modules screen now.
5. Press [ ENTER ] to accept Active Modules list.
Now the module should be active.
19
To Next Page
Loading...
