SwissMicros DM41X - Load DM41 State File; Save DM41 State File; Load RAW Program; Save RAW Program

6.2.1. Load DM41 State File >
Used for loading the .d41 state files. By default from the /STATE/ directory of the FAT disk.
Note that this loads only calculator memory and doesn’t affect state of currently loaded modules.
To load calculator state
• Select the program to load using the [ ▲ ] and [ ▼ ] keys
• [ ENTER ] to load the selected state file
• Warning is displayed that current calculator state will be lost. Proceed with [ ENTER ].
Then calculator state is updated from the selected file.
6.2.2. Save DM41 State File >
Used for saving calculator’s state (i.e. contents of memory and CPU registers) to a .d41 state file. By
default to the /STATE/ directory of the FAT disk.
• Select file from list (for overwrite) or <New File> if you want to enter new filename.
Confirm with [ ENTER ]
• [On <New File>] Enter new filename. [ SHIFT ] toggles input mode between lower/upper case
and numbers.
Confirm with [ R/S ] or [ Alpha ].
Then calculator state is saved to selected file.
6.2.3. Load RAW Program >
Used for loading the .raw program file from FAT disk. By default from the /PROG/ directory of the
FAT disk.
This is functional equivalent of GETP extended memory command. Only this reads from FAT disk
instead of extended memory.
To load program file:
• Select the program to load using the [ ▲ ] and [ ▼ ] keys
• [ ENTER ] to load the selected program file
The program is loaded into calculator memory.
6.2.4. Save RAW Program >
Used for saving program to a .raw file to FAT disk. By default to the /PROG/ directory of the FAT disk.
This is functional equivalent of SAVEP extended memory command. Only this writes to FAT disk
instead of extended memory.
• Put the name of the program (the topmost global label) you want to save in Alpha.
25