19
GO User Guide
(2) Single beds with table and shelf:
To add a shelf underneath the table, remove the second
bed/table panel from the overhead storage area. Lay the
panel sideways between the two bed frames so the
anges seat securely and slide to the front, up against
the pod bottom wall.
(2) Single beds with table and bench:
To add a third bench seat at the rear end of the table,
remove the second bed/table panel from the overhead
storage area. Lay the panel sideways between the two
bed frames so the anges seat securely and slide to the
rear, as close to the door as possible.
(2) King-and-a-half sized bed:
To create a 10 1/2’ x 7’ sleeping area, remove both bed/
table panels from the overhead storage area. Lay both
panels sideways between the two bed frames so the
anges seat securely and slide both forward, up against
the pod bottom wall. Place two smaller mattresses on
panels to complete a full king-and-a-half sized bed.
Completed king-and-a-half sized bed, with mattresses in place
To Next Page
Loading...