38
GO User Guide
Section 6. Rack and tent pod assembly
Rack and tent pod assembly overview
The rack and tent pod assembly is attached to the top of the four telescoping lift tubes and is
designed to disconnect simply, with no tools! The rack enables you to attach a large
assortment of toys, racks, accessories and components to your GO camping trailer. The rack
system is designed to be compatible with most of the major rack manufacturers components.
Loading and disconnecting the rack and tent pod assembly
The rack is designed to carry bikes, kayaks, boats, storage boxes, and more. Always follow the
manufacturers’ instructions when attaching various rack accessories from the rack
manufacturers. If you have any questions regarding installation, call us at (828) 393-4927 or
email info@sylvansport.com
The rack and tent pod assembly is designed to be easily removed, without the need for tools,
to give you a true open-top utility trailer. There are two basic methods for removing the rack
system: manually or with use of a hoist system, such as a canoe or kayak lift in your garage.
For thorough details on how to use these methods, contact SylvanSport customer service at
(828) 393-4927, for a technical bulletin.
The bed platforms are also designed for easy removal. By inserting a athead screwdriver into
the bed support rotation slot, you can easily remove the spring-loaded bed support rotation
pin. For more information please contact SylvanSport customer service at (828) 393-4927.
Maintenance
Maintenance on the rack and tent pod assembly should only require a visual inspection. When
inspecting the system, check to make sure that all the parts are not damaged or bent and that
all the hardware is present and properly tightened.
Tent pod assembly (rear) suspension arm.
Front connection - Rack to tent pod assembly.
To Next Page
Loading...