41
GO User Guide
Section 8. Electrical system
Electrical system overview
The GO electrical system consists of a at 4-pin connector, the main cable, 2 amber side
marker lamps (front), 2 red side marker lamps (rear), 2 rear stop/tail/turn lights and a
license plate light, located in the removable tailgate and connected by a waterproof
connector.
Preparing your tow vehicle
Your tow vehicle simply needs to be wired for a standard 4-pin trailer connection. This is
typically done professionally at the time of your vehicle tow package installation. More
information on this can be found in the Section 2. Towing Guidelines (Electrical) section.
Electrical access to GO interior
When an external power source from a campground or generator is available, you may run
an extension cable from that source, to the interior of the GO. Simply run the cable between
the Tent pod bottom and the tent, where the Velcro connection is located. Peel back a small
patch and feed the cable through.
Maintenance
Maintenance on the electrical system should include frequent visual inspections, cleaning
and the occasional replacement of lamp bulbs, should they fail. Be sure to keep the 4-pin
connector off the ground, safe and clean.
Electrical extension cord into GO from external power source
To Next Page
Loading...