30
GO User Guide
Camping mode (from Travel mode)
1. Park the GO on a level surface to ensure the lift
system will operate smoothly, and to prevent
diculty in sleeping. Tip: Use a small level to get
the deck as level as possible.
2. At the corners, beneath the deck, are the corner stabilizer jacks. Drop the jacks and use
the stabilizer jack adjustment bar to “ne tune” your leveling position.
3. Remove the 4 ring grip pins from the rack feet, if attached.
4. Remove both Velcro straps from bed platforms, (18” front and 24” rear).
5. Insert the winch handle (stored in the storage box lid) into the winch opening (the
“mouse-hole” under the storage box) and raise the lift system to its fully raised position.
The lift tubes closest to the winch have an indicator on them which will tell you when you
are fully raised. Do not exceed this height or you can seriously damage your lift
system.
6. Insert the bed support poles into the key-slot of the support mounting brackets, on the
bottom of the main frame. Turn the bed support poles to lock them in and prevent them
from backing out.
7. While standing centered to the GO deck, lift and rotate the bed platforms outward and
down until parallel to the ground, being careful not to hit the locating pins as you rotate.
8. Line up bed support pole tips with key-slot in the bed platforms and turn them to secure.
This will lock your bed platforms into a rigid position.
9. Drop the tailgate down onto the ground, to function as your step into the camping
trailer. Using the step, stand on the back of the GO and reach up to the tent pod release
latch. Give the latch a gentle pull downward and the tent pod bottom will release and
begin a controlled drop.
10. Step down and walk the tent pod bottom toward the front of the GO. The tent will unfurl
as you push forward. Lower the lift system enough to lock the tent pod bottom into
secure position, then turn back counterclockwise one click - to re-engage the lift
system clutch.
11. If you have a GO deck pad, place it on the deck, before setting up tent.
12. Gently unfold the tent and pull toward the outside corners of the bed platforms. Attach
all straps and plastic hooks at bed platform corners, at base of frame rear pillars, at
front of deck, and at rear lift system tubes as shown in System drawing: Camping mode.
13. Remove the tent poles and click together to form three separate tent poles. The two
shorter grey ones (with the “spike” ends) are for the sides, the longer orange one is for
the vestibule. Feed the side tent poles through the sleeves and into the pole connector
grommets. Feed the vestibule pole through the vestibule sleeve and into the bed support
frame holes.
To Next Page
Loading...