32
GO User Guide
Take-down instructions :
Transport mode to Travel mode
To return the GO to Travel mode from Transport mode, start by making sure you are parked on
a level surface. Then follow these basic steps:
1. Remove the ring grip pins from the rack feet, so the lift system can raise and lower
freely.
2. Remove all ratchet straps from the frame connection points.
3. Place the tailgate into raised position to receive the bed support panels and secure with
straps.
4. Using the winch handle, raise the lift system approximately 6 inches.
5. Raise either of the bed support panels and rotate inward and down to rest on the
tailgate. Repeat this step on the other bed support panel.
6. Lower the lift system to rest on the vertical frame pillar pins.
7. Replace the ring grip pins on all four rack feet to secure.
8. Be sure the velcro tailgate strap is tight and secure.
Note: Be sure not to misplace the extra ring grip pins.
To Next Page
Loading...