EasyManua.ls Logo

sylvansport GO - Suspension System; Suspension System Overview; Tires and Wheels; Spare Tire

sylvansport GO
58 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
33
GO User Guide
Camping mode to Travel mode
To return the GO to Travel mode from
Camping mode, start by making sure you
are parked on a level surface. Then follow
these basic steps:
1. Inside - remove the two bed panel packs and fold. Place them into front wall recess and
secure with the bungee strap provided.
2. Unzip the overhead screen access panel, rotate the overhead tent pod frame down, and
place the bed/table panels on locating pin, secure with clip, rotate back up and into
storage position.
3. Outside - detach all connection straps for the tent.
4. Carefully remove the three aluminum shock poles from the tent sleeves, fold and stow in
their bag and place in the storage box.
5. Using the winch handle, raise the lift system (approx.) 1 turn to free the tent pod bottom.
6. Pull the tent pod bottom toward the back of the GO to a diagonal position and begin to
carefully gather up the tent.
7. Gently stuff the tent into the bottom of the tent pod, taking care not to damage or rip the
fabric. Fold the half-moonend panels carefully inward as well, taking care not to bend,
pinch or damage the poles when closing tent pod. Continue raising the tent pod bottom
and stung the tent until you are able to close and latch the tent pod top and bottom
together (you should hear two clicks). Note: you may need to lower the lift system to
help with your reach.
8. Place the tailgate into raised position to receive the bed support panels.
9. Raise either of the bed support panels and rotate inward and down to rest on the
tailgate; repeat with other bed support panel.
10. Secure tailgate and bed support panels with velcro straps.
11. Lower the lift system to rest on the vertical frame pillar pins (watch ngers as rack
meets corner pillars). Once the tent pod frame is properly seated, turn the crank handle
counter-clockwise one click, to re-engage the clutch.
12. Replace the ring grip pins on all four rack feet.
The lift system requires that the GO camping trailer
be parked on a relatively at surface. Some care
should be taken when choosing a campsite, to
position the camping trailer level.

Table of Contents