sylvansport GO - Important Information at a Glance

8
GO User Guide
Important information at a glance
Throughout the GO user guide there is valuable information to help guide you through travel
preparation, the three modes, set-up and takedown, vehicle loading and other processes.
Some things are fundamental to the safety, longevity and enjoyment of the GO. This list is a
compilation of very important things to learn and remember while
operating the GO:
Before doing any set-up:
Take care to position the GO on as level a surface as possible.
Raising the lift system:
Be careful not to overextend. Do not raise the lift system past the indicator mark on the lift
tube or possible damage may occur.
Lowering the lift system:
Do not lower the lift system past the point of resistance. As soon as you feel slack, STOP
LOWERING the lift system. Turn the crank handle clockwise (one click) to re-engage the
winch clutch and take up any slack in the cable.
Stabilizer jack adjustment bar:
Be sure bar passes through both holes on stabilizer jack before applying force
Pack and seal wheel bearings:
It is important to re-pack and seal wheel bearings every 10,000-12,000 miles. Replace the
worn seals with new ones each time. SylvanSport can perform this service at the factory. A
certied mechanic can do this or you can do it yourself, if you are condent. SylvanSport
offers a Technical Bulletin with valuable information on this procedure.
Tent poles:
Take care not to bend, pinch or damage the poles when closing tent pod. This includes the
“half moon” poles which are mounted in the tent end “hoops”.
Flammability warning:
Keep all ame and heat sources away from the tent fabric.
Knurled indicator marks on lift tube.
Stabilizer jack adjustment bar, passing
through both sets of holes on stabilizer
jack.