35
GO User Guide
The lug nuts, used to attached your wheels to your axle, should be checked at 50 miles and
again at 200 miles when your GO is new. After that, it is advised you check your lug nuts prior
to every trip and every 250 miles. Failure to do this could cause wheel loss and an accident.
Self- lubricating wheel bearings
The GO camping trailer comes equipped with Dexter brand, self-lubricating wheel bearings.
Use standard #2 axle grease. Remove the black dust cap, attach manual grease gun to
grease tting, slowly inject grease while rotating wheel until excess is expelled around
perimeter of recess. Wipe off the excess grease and replace cap.
Maintenance
Maintenance on the suspension system includes visual inspection and lubrication. When
visually inspecting the system, check to make sure the tires appear to be fully and evenly
inated to each other. Also be sure the tread hasn’t worn to an unsafe level. The
self-lubricating wheel bearings should be properly lled with grease and should be
inspected, repacked and sealed every 10,000 - 12,000 miles.
The spare tire should also be inated to ensure it is useable in case of emergency.
The GO is designed to use 20.5x8.0-10 tires. Use of
tires other than this size is not recommended and
may void any warranties.
Be sure tires are properly inated and tire tread
is not worn excessively.
To Next Page
Loading...