sylvansport GO - Travel Mode Set-up

27
GO User Guide
Section 3. Set-up and take-down instructions
Set-up overview
The GO is very versatile and operates in three basic congurations:
1. Travel mode 2.Transport mode 3. Camping mode.
In Travel mode, the GO is in its fully compacted position. In this conguration there is ample
space on the rack to carry bikes, kayaks, and any other gear your rack accessories can
accommodate. Below the rack and tent pod assembly, there is an area (the deck) roughly
7’ long x 4’ wide by 17” tall to carry luggage, coolers, building materials, etc. In this
conguration the bed platforms are folded inward, the tailgate is up, and the pins are set.
In Transport mode, the GO is capable of carrying large items, such as a motorcycle, ATV or
ride-on mower, or multiple bicycles or kayaks. In this conguration, the lift system is partially
raised and the bed platforms are raised to a vertical position. When loading vehicles
(motorcycles, ATVs, ride-on mowers, which would typically require a loading ramp), pulling
the set pin out of the tongue enables the trailer to control-tilt, allowing for an easy load with
no ramps. The tailgate is easily removable and replaceable to give clearance while loading.
Connecting and securing the ratchet straps, provides additional bracing. The tailgate can be
replaced and secured, and inserting all the set pins nishes securing the GO for transit.
In Camping mode, gear is unloaded from the deck, ring grip pins are removed, and the lift
system is fully raised. Bed platforms rotate outward and parallel with the ground. The tent is
opened from the tent pod and drops down so the tent bottom sits on the deck. Tent set-up is
simple, with three poles, and built-in hooks and straps. The interior can be set-up in multiple
congurations, whether you’re a solo camper or have a family of four.