37
GO User Guide
Maintenance
Maintenance on the lift system includes visual inspection and lubrication. Make sure the
cables are all running through their pulleys and holes correctly and that they aren’t worn
excessively. Proper lubrication of the lift tube main housing should be done by using standard
#2 axle grease. Attach the grease gun to the standard tting on the housing and ll until
slight overow occurs.
• Lift tube main housing lubrication: Frequency of lubrication depends on usage of the GO.
Average use = once every twelve months, more frequent use = once every six months.
Raise the lift system fully (stop at the indicator marks). Slowly inject 3 squirts of grease
in one of the 2 grease ttings on main housing, as the lift system is slowly lowered.
Repeat the process by injecting 3 squirts of grease in the other grease tting on the
main housing.
• Inspect all cables and cable pulleys.
• Spray lubricant (dry silicon spray) on lift tubes. Wipe off excess with clean, lint-free rag.
Do not use any grease of any kind on the lift tubes.
The lift system requires that the GO be parked on a
relatively at surface. Care should be taken when
choosing a campsite, to position the GO level.
Do not lower the lift system past the point of
resistance. As soon as you feel slack, STOP
LOWERING the lift system.
Do not raise the lift system past the indicator mark
on the lift tube or possible damage may occur.
Grease tting locations.
To Next Page
Loading...