2. MAINTENANCE INFORMATION
2-7
Drive Belt
Loosen the 2 clamp strips of left crankcase cover,
and then remove the left crankcase cover vapor
hose.
Remove 9 bolts of the engine left side cover and
the cover.
Check if the belt is crack or worn out.
Replace the belt if necessary or in accord with the
periodical maintenance schedule to replace it.
Width limit: 22.5 mm or above
Drive Chain
Check the drive chain
Park the ATV on a level ground, and shift the
transmission onto neutral.
Measure the drive chain slack midway between
the sprockets.
Chain slack: 15~25mm (5/8~1 inch)
Adjust the chain slack
Loosen the axle holder lock nuts and bolts
Loosen drive chain adjusting bolt lock nut and turn
drive chain adjusting bolt until get the correct
slack.
Tighten the axle holder nuts and bolts.
Torque: 3.25kgf-m
Teeth
Width
To this chapter contents
2 nuts
Adjustment bolt
Clamp strips
9 bolts
Lock nut
To Next Page
Loading...
