7. INSPECTION AND MAINTENANCE BEFORE RIDING
40
Brake 2
(Replenishment of brake fluid)
1.Loosen the screws and remove the master cylinder cover.
2.Wipe clean foreign materials , dirt around the reservoir, being careful not to let foreign
materials fall into the reservoir.
3.Remove the diaphragm plate and the diaphragm.
4.Add brake fluid to upper level.
5.Install the diaphragm plate and the diaphragm, and install the master cylinder cover. nstall
the diaphragm plate and the diaphragm, and install the master cylinder cover.
6.Please note the diaphragm direction, and do not let foreign materials fall into the reservoir.
And tighten the master cylinder cover securely.
CAUTION:
y To prevent chemical reaction, please do not use brake fluids other than those
recommended.
y Do not fill above the upper limit when adding brake fluid and avoid dropping on
painting or plastic components to prevent damage.
To Next Page
Loading...
