7. INSPECTION AND MAINTENANCE BEFORE RIDING
43
Oil filter cleaning
Open the filter nut assembly of the element, and remove the element. Remove the
foreign materials from the element by using a gasoline or air spraying gun.
WARNING:
y Oil level will not be correct when checking the oil level with the motorcycle parked on an
unleveled ground or immediately after the engine stopped.
y Engine and exhaust pipe are hot right after engine stopped. Pay special attention not to
get burned when checking or replacing engine oil.
Inspection of fuel level
y Uses main parking places standpoint ATV in the level ground,, turn the main switch to
“ON” position, check if the fuel meter needle moves.
y Fuel gauge may be defective or electric circuit disconnected if there is some fuel in the
tank, but the needle does not move. Please ride slowly to an authorized service
station to have your ATV checked.
WARNING:
y Do not check the fuel level or refuel while the engine is running. It is not necessary to start
engine to check the fuel level.
y Make sure fuel cap on tank is closed tightly before riding ATV.
y Do not run engine in an enclosed space. Ensure proper ventilation as exhaust fumes
may be dangerous and over exposure to same may result in illness, injury or death.
y There is a danger of fire and explosion when handling fuel. Never refuel in an enclosed
space.
y Do not over fill the fuel tank.
y Do not spill fuel onto hot engine or related parts.
To Next Page
Loading...
