7. INSPECTION AND MAINTENANCE BEFORE RIDING
48
Spark plug replacement & inspection
(1) Spark plug cap
CHECKING THE SPARK PLUG
y Remove the cap of spark plug cable (remove the spark plug using the spark plug wrench
in the tool kit.
y Check the electrode if it is dirty or fouled by carbon deposits.
y Remove the carbon deposits on the electrode with steel wire, and clean the spark plug
with gasoline, then, wipe dry with a rag.
y Check the electrode, and adjust its gap to 0.8 mm. (Check it with a feeler gauge)
y Hand tight the spark plug as far as it can go and then tighten it another 1/2~3/4 turns with
a wrench.
CAUTION:
y The engine is extremely hot after running. Allow ATV to cool completely before
removing the spark plug to avoid being burned or other possible injury.
※Use only spark plugs suitable for the engine specifications of this motorcycle
recommended by the manufacturer. (Refer to specifications.)
(1)
0.8mm
To Next Page
Loading...
