■ The storage servers, disk pools, and storage units are cleaned up on the
master server.
■ The backup data on the disk is preserved.
If you choose No the following occurs:
■ NetBackup catalog images are retained.
■ The backup data on the disk is preserved.
Note: If you want to remove the backup data, run the following command from
the NetBackup Appliance Shell Menu before you proceed.
Main_Menu > Support > Storage Reset
14
Enter the storage configuration properties to configure storage pools for
AdvancedDisk, for Deduplication (MSDP), or both.
When you configure storage pool sizes after a reimage process, the default
storage sizes are displayed. If you adjusted the storage pool sizes before the
reimage, those new storage pool sizes become the new default values that
appear. However, the default disk pool name and the storage unit name that
appear are the same default names as in the initial configuration process. If
you changed the disk pool name and the storage unit name before the reimage,
you must enter the names that you had chosen again during the reconfiguration
process
Note: To skip this step enter 0 when you are prompted for the size. This also
deletes any existing data for that partition.
If you enter a 0 when you are prompted and a storage partition does not exist,
then a partition is not created. If you enter 0 and a partition already exists then
the partition is deleted and any existing data is also deleted.
To configure an AdvancedDisk storage pool provide the following information:
■
AdvancedDisk storage pool size in GB/TB (e.g., 50 GB)
[1.6395 GB..51.8 TB]:
■
AdvancedDisk diskpool name:
■
AdvancedDisk storage unit name:
152Disaster Recovery
Disaster recovery scenarios
To Next Page
Loading...
