Symbol LS 4208 - Scanning with Intellistand

Scanning
2-9
Scanning
with
Intellistand
When the scanner is placed in the Intellistand, the scan pattern selected in hand-held triggered mode continues (see Scan
Pattern
on
page
4-7
).
To operate the scanner in Intellistand:
1. Ensure the scanner is properly connected to the host (see the appropriate host chapter for information on
host
connections).
2. Insert the scanner in Intellistand by placing the front of the scanner into the stand’s “cup.”
Cup
Scanner
Holder
Angle Adjustment Knob
Height
Adjustment
Knob
Figure
2-7.
Inserting
the
Scanner
in
the
Intellistand
3.
Use
the
Intellistand
’
s
adjustment
knobs
to
adjust
the
height
and
angle
of
the
scanner.
4. Present the bar code.
When the bar code is in view, the scanner emits a full scan line. After 3 minutes, the
scanner
automatically
switches
to
a
reduced
scan
line.
After
1
hour,
the
scanner
automatically
switches
to
blink
mode.
5.
Upon
successful
decode,
the
scanner
beeps
and
the
LED
turns
green.
For
more
information
about
beeper
and
LED
definitions,
see
Table
2-1
and
Table
2-2
.