Symbol LS 4208 - RS-232 Host Parameters

Parameter
Stand
ard
ICL Fujits
Winco
r-
Nixdo
rf
Wincor-Nixd
orf
Olivetti Omron
Transmit Code ID No Yes Yes Yes Yes Yes Yes
Data Transmission
Format
Data as
is
Data/Su
ffix
Data/Su
ffix
Data/Suf
fix
Data/Suffix Prefix/Data/Su
ffix
Data/Suffi
x
Suffix CR/LF
(7013)
CR
(1013)
CR
(1013)
CR
(1013)
CR (1013) ETX (1002) CR (1013)
Baud Rate 9600 9600 9600 9600 9600 9600 9600
Parity None Even None Odd Odd Even None
Hardware
None RTS/CT
S
Option
None RTS/CTS
Option
3
RTS/CTS
Option
3
None None
Software
Handshaking
None None None None None Ack/Nak None
Serial Response
Time-out
2 Sec. 9.9 Sec. 2 Sec. 9.9 Sec. 9.9 Sec. 9.9 Sec. 9.9 Sec.
Stop Bit Select One One One One One One One
ASCII Format 8-Bit 8-Bit 8-Bit 8-Bit 8-Bit 7-Bit 8-Bit
Beep On <BEL> Disable Disable Disable Disable Disable Disable Disable
RTS Line State
Low High Low Low Low = No data
to
send
Low High
Prefix None None None None None STX (1003) None
RS-232
Interface
6-5
RS-232
Host
Parameters
Various RS-232 hosts are set up with their own parameter default settings (Table 6-2). Selecting the ICL, Fujitsu,
Wincor-Nixdorf
Mode
A,
Wincor-Nixdorf
Mode
B,
Olivetti,
Omron,
or
terminal
sets
the
defaults
listed
below.
Table 6-2. Terminal Specific RS-232
*In
the
Nixdorf
Mode
B,
if
CTS
is
Low,
scanning
is
disabled.
When
CTS
is
High,
the
user
can
scan
bar
codes.
**If Nixdorf Mode B is scanned without the scanner connected to the proper host, it may appear unable to scan. If this happens, scan a different RS-232
host
type
within
5
seconds
of
cycling
power
to
the
scanner.