Symmetricom ET6000 User Manual

APPENDIX C
Note: Each of the three DIP switches works identically.
SW1 controls code output on rear panel BNC J3a or J3d.
SW2 controls code output on rear panel BNC J3b or J3e.
SW3 controls code output on rear panel BNC J3c or J3f.
The modulation ratio and amplitude can be individually adjusted for each of the three channels
as follows:
Table 01-2
Amplitude and Modulation Radio Controls
Channel 1
(BNC J3)
Channel 2
(BNC J5)
Channel 3
(BNC J6)
Modulation
Ratio
R10 R12 R14
Amplitude R11 R13 R15
Detailed definitions and specifications for each of the time codes that are generated by the Three
Channel Encoder are provided on the following pages.
C-4 ET6xxx ExacTime GPS TC & FG (Rev C) Symmetricom Inc

Symmetricom ET6000 Specifications

General

Brand	Symmetricom
Model	ET6000
Category	Receiver
Language	English